Flap Controller PLC v2

Quick specs

What’s in the box

• 1 × Flap Controller PLC v2 unit
• 1 × 12V DC power adapter (1.5A)
• 1 × RF433 remote (4-button)
• 1 × Quick-start card

Tools you’ll need

• Phillips screwdriver
• Wire stripper
• Multimeter (recommended)
• A phone or laptop on 2.4 GHz Wi-Fi

Step-by-step installation

1. 1

   Unbox & inspect

   Open the package and check for visible damage.

2. 2

   Choose installation location

   Mount inside a dry, ventilated enclosure. Leave 10 mm clearance around the labelled terminals.

3. 3

   Mount the unit

   Use the mounting holes, or clip onto a 35 mm DIN-rail. Same footprint as v1.

4. 4

   Switch off mains power

   Important, isolate the 230 V circuit before wiring either relay output.

5. 5

   Connect 12V DC input

   Wire the supplied 1.5A adapter to V+ and GND. Polarity-protected.

6. 6

   Wire the loads

   v2 has two independent relays: CH1 COM/NO and CH2 COM/NO. Keep each channel under 2 A.

7. 7

   Power on & check LEDs

   PWR LED solid; WIFI LED blinks during hotspot mode. CH1/CH2 LEDs show relay state.

8. 8

   Join the device hotspot

   Connect to apiHW-FlapV2-XXXX on your phone, no password in setup mode.

9. 9

   Open the web interface

   Visit http://192.168.4.1 in your browser.

10. 10

    Configure your Wi-Fi

    Enter your Wi-Fi credentials. The unit reboots and joins your network.

11. 11

    Pair the RF remote

    Hold PAIR for 3 s, then press any button on the remote within 10 seconds. Assign each remote button to CH1 or CH2 from the web UI.

12. 12

    Test both channels

    Toggle CH1 and CH2 from the web interface and the remote. Verify each load activates independently.

13. 13

    Enable OTA updates (optional)

    In Settings → Firmware, enable automatic OTA updates so the unit stays on the latest firmware.